Leprecon APC Architectural Preset Control User Manual download pdf (Page 14)

8. Installing panels and faceplates

APC panels consist of three parts:

· Faceplate - 1/8" aluminum snap-on cover, painted and screened.

· Mounting plate - Sub panel that screws to the mounting box.

· Board stack - button and processor boards that are pre-assembled to the mounting

plate.

To install the panels:

1. Separate the faceplate from the mounting plate. A small screwdriver can be used

to separate the panels. Remove the cover carefully to avoid bending the LED

indicators.

2. Attach the mounting plate and board stack to the electrical box using the screws

provided. Make sure all configuration jumpers are set before screwing down the

panel.

3. Do NOT attach the faceplate for the Master panel until programming is complete.

Faceplates can be installed on the slave panels, no further access is needed to

these boards. Simply align the faceplate with the mounting plate, and gently press

into position.

1 2 ... 9 10 11 12 13 14 15 16 17

No comments

Leprecon APC Architectural Preset Control User Manual Page 14