1ULD-360DMX and ULD-360DMX-HPUSER’S MANUAL©Copyright Leprecon LLC. 2005 - 2008All rights reservedPublication 21-1046 Rev BThis document is the propert
- 10 -The UP/DOWN keys change the value for the start address. The ULD-360 uses thechanged value immediately and permanently saves it after 10 seconds
- 11 - After changing the mode the colon will blink to indicate new data has been entered.Press the ENTER key saves the change, and advance to the nex
- 12 -Status MenuWhen the ULD-360 is in the Channel mode, pressing ‘MENU’ again will start the Statusmode. When Status mode starts, the state of each
- 13 -Once the input levels for all dimmer channels have been shown, the display will thenindicate the output level for each channel. This is indica
- 14 -Configuration DataIf you press the Menu button while in the status display, various factory configurationdata will be seen. These features are
- 15 -7) ServiceService policyThe LD360 DMX is designed for a long, trouble free life. If you suspect that you have adimmer problem, the first step is
- 16 -8) DMX 512 InformationThe following information is a summary of the USITT 1990 standard for dimmers andcontrollers. A complete copy may be obtai
2Table of ContentsEndplate Illustration – ULD-360DMX-HP ...31) Introduction ...
3Endplate Illustration – ULD-360DMX-HPMenuEnterData InULD SeriesLine ALine BData OutONIOOFFONIOOFFd 0 0 DMX OutDMX InLED displayBreaker ‘A”
- 4 -1) IntroductionThe new ULD series dimmer is designed to be a capable and reliable solution fortemporary and portable dimming requirements. With
- 5 -Control inputThe ULD-360 DMX accepts DMX 512 1990 as specified by USITT. Reliable DMXsystems require cable rated for data communication at 250K b
- 6 -3) Optional Wireless DMXAll Leprecon ULD models are available with wireless DMX capability. This system hasbeen developed by Wireless Solutions,
- 7 -The LED located on the dimmer endplate shows the status of the wireless link. OFF – Dimmer is not linked to any transmitter. DMX cable input can
- 8 -3) InstallationMountingThe ULD-360 is designed for vertical mounting. The top hanging bracket has a pre-punched hole for a standard ½” pipe clam
- 9 -5) Front Panel ControlsThe ULD-360 dimmer uses a 4-digit display and four entry switches to set packfunctions, and display operating status.Reset
Comments to this Manuals